LAN settings

• Wi-Fi

  Enables/Disables Wi-Fi.

• Wireless Direct

  Enables/Disables Wireless Direct.

• Wired LAN

  Enables/Disables Wired LAN.

• Confirm LAN settings

  The LAN setting information is displayed.

• Advanced setup

  • Set printer name

    Specifies the printer name.

    Note

    • You cannot use the same printer name as that already used for other LAN connected devices.

    • You cannot use a hyphen for the initial or last character of the printer name.

  • TCP/IP settings

    Performs IPv4 or IPv6 setting.

  • WSD settings

    Perform settings to use WSD.

  • Bonjour settings

    Perform settings to use Bonjour.

  • LPD settings

    Perform settings for printing with LPD.

  • RAW settings

    Enables/Disables the RAW printing.

  • LLMNR settings

    Enables/disables LLMNR (Link-Local Multicast Name Resolution). If you select Enable, you can determine the printer's IP address from the printer name even in an environment without the DNS server.

  • SNMP settings

    Perform settings for using SNMP to manage and control the printer.

  • IPP Settings

    Perform settings for printing with IPP.

  • CHMP settings

    Perform settings for communication at the time when printer drivers or applications acquire the information on status, paper, and job log, from the printer.

    Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted communication.

    Note

    • To use CHMP for encrypted communication, you need to register the printer's root certificate to your computer.

      • Registering Printer's Root Certificate to Local Computer for SSL Communication

    • CHMP is a Canon proprietary protocol.

  • DRX settings

    When enabled, data is received intermittently during network connection.

  • IP filtering

    Allows or denies access for specific IP addresses.

    Settings for both IPv4 and IPv6 addresses can be specified.

    Important

    • If the device address for the administrator has been set to rejection by mistake, select Various settings on the HOME screen of the operation panel, and then select Printer settings > Reset settings > LAN settings only in this order, and initialize network information of the printer.

      After resetting, perform setup again as necessary.

  • MTU

    Performs the MTU settings.

  • Easy wireless connect settings

    When set to Auto start: ON, the device will automatically put into the standby mode for easy wireless connect.

    To prevent the device from putting into the standby mode for easy wireless connect at unintended times, set to Auto start: OFF.